The operation principle is the next: housed inside a plastic box, it can be carried by a robot, a bicycle, or another vehicle. The device has a small lamp and a pendulum sensor (X1). In normal conditions, the pendulum does not make any contact with the loop. But in the case of a change in the speed (breaking) or balance, contact is made, triggering the circuit. This causes the lamp to glow for some seconds due to the charge stored in the capacitor.

The loop and the pendulum must be rigid enough to not trigger the circuit with the normal balance or a light change in the speed. The circuit cannot trigger when passing through small ground undulations or holes.

The sensor must be positioned in a manner that it triggers only when the vehicle brakes. The device is powered by common cells and, by replacing the lamp, you can use a Jumbo Red LED. Connect it in series with a 33 ? to 100 ? resistor. Figure 1 shows the diagram of the device.

 

Figure 1 – The brake light uses only one transistor and can control a lamp or LED
Figure 1 – The brake light uses only one transistor and can control a lamp or LED

 

 

 

Figure 2 shows how the components can be placed on a printed circuit board. Since the circuit is not critical, the components can also be assembled on a terminal strip;

 

Figure 2 – Component placement on a PCB
Figure 2 – Component placement on a PCB

 

 

The lamp is a 6 V x 50 mA type. Powerful lamps are not recommended, since the circuit is powered by AA cells. If you intend to use 100 mA or 200 mA lamps, powering the circuit by C or D cells, replace the transistor with a BD135, BD137 or TIP31. You may probably have to increase the capacitor C1.

The sensor is made using uncovered copper wire 16 or 18 AWG. The ballast can be a small metal ball. Testing is very easy. Power the circuit and touch the sensor to make the pendulum contact the loop. The lamp will glow for some seconds. Once the operation of the device was verified, you can install it.

 

Semiconductors:

Q1—BC548 or equivalent—general purpose silicon NPN transistor

Resistors: (1/8 W, 5%)

R1—10 kΩ—brown, black, orange

R2—1 kΩ—brown, black, red

 

Capacitors:

C1—47 μF to 470 μF x 6 V—electrolytic

 

Other:

X1—sensor—see previous text

X2—6 V x 50 mA — incandescent lamp

S1—On/off switch

B1—6 V—4 AA cells with holder

Printed circuit board, plastic box, wires, solder, etc.

 

 

Datasheets


N° of component