You can probe small components with this simple circuit. Components such as diodes, lamps, fuses, coils, switches, and many others can be tested with this tester, which produces a continuous tone with low-resistance devices.

The circuit can be powered from 6 or 9 V supplies, and current drain is very low. With the tone off, current drain is only 0.5 mA, and when the tone is on, current drain is about 5 mA. R1 adjusts sensitivity.

A schematic diagram of the Fixed-Tone Continuity Tester is shown in Fig. 1.

 

Figure 1 – Schematic diagram of the tester
Figure 1 – Schematic diagram of the tester

 

All of the components can be housed into a small plastic box. R1 adjusts sensitivity.

The circuit can be powered from AA cells or a battery. X1 is a piezoelectric transducer or crystal earpiece.

IC1 - 4093 CMOS integrated circuit

X1 - Piezoelectric transducer or crystal earpiece

S1 - SPST toggle or slide switch

B1 - 6 or 9 V, four AA cells or battery

P1, P2 - Black and red probes

R1 - 1,000,000 ohm - potentiometer

R2 - 10,000 ohm, 1/4 W, 5% - resistor

R3 - 39,000 ohm, 1/4 W, 5% - resistor

C1 -l 0.022 µF - ceramic or metal film capacitor

C2 - 100 µF, 12 WVDC - electrolytic capacitor

 

Datasheets


N° of component